OBDLink EX [STN2231] ChangeLog
OBD Solutions LLC


v5.12.2 - 2025/10/30
--------------------

- BUG: Fixed an issue where CAN multi-frame message transmission would cause the device to lock up after 35 minutes of uptime



v5.12.1 - 2025/10/16
--------------------

- NEW: Added the Batched Commands feature, which supports sending multiple commands/requests in a single prompt
- NEW: Added the STBC command for enabling and disabling the Batched Commands feature
- NEW: Added the STBCOF command, which sets the output format for batched commands
- NEW: Added an optional parameter to STM and STMA commands to exit monitoring after reaching the specified message count
- NEW: Added the STITW command to set ISO protocol W timings

- CHG: STCSTM now also sets ISO 11898 inter-frame delay for segmented messages

- BUG: Fixed handling of ATCRA, ATCF, and ATCM so their values are preserved when ATSP or ATTP are issued, matching ELM327 behavior
- BUG: Fixed rare issue where an overflow condition could reduce message delay times
- BUG: Fixed rare ISO 15765 flow-control frame transmission failure during concurrent multi-frame reception
- BUG: Fixed INTERNAL ERROR when receiving more multi-frame messages than specified
- BUG: Fixed ATCRA not restoring default filters when used without a parameter
- BUG: Fixed bug, STPX now properly sends 29-bit CAN messages when the AT/ST protocol is configured to 11-bit CAN



v5.10.3 - 2024/02/01
--------------------

- NEW: Added the STIP command to set message parity for ISO-14230 protocols
- NEW: Added the STIIAP command to set initialization address parity for ISO-14230 protocols

- CHG: Changed STIFI command to keep ISO-14230 connection open post-initialization

- BUG: Fixed user input validation for STPPMA
- BUG: Fixed an INTERNAL ERROR when the periodic message protocol doesn't match the current protocol



v5.8.1 - 2023/03/29
-------------------

- BUG: Fixed a bug where STI/STDI/STDIX may return the wrong device ID or hardware revision
- BUG: Fixed ATCF not setting filter properly
- BUG: Fixed <DATA ERROR for multi-frame messages while in monitoring mode



v5.7.1 - 2022/09/20
-------------------

- BUG: Fixed factory reset issue



v5.7.0 - 2022/09/16
-------------------

- NEW: Added support for PP 1D
- NEW: Added support for PP 1C
- NEW: Added support for PP 14

- CHG: PP 0C sets UART baud rate to 9600 when value is 00
- CHG: ATCRA now accepts "X" as a don't care
- CHG: Relaxed ISO initialization timing to work better with non-compliant ECUs
- CHG: Changed STIP4 to saturate at 262 ms

- BUG: Fixed CAN baud rate divisors for Programmable Parameter 2D and 2F



v5.6.24 - 2022/03/22
--------------------

- NEW: Implemented STPFEPS command to control FEPS adapter over L-Line

- BUG: Fixed async CAN not handling cancellation and not reporting the error from aborted frames
- BUG: Fixed async CAN memory leak caused by bus stuck in dominant state
- BUG: Fixed STPPMD locking up with non-existent handles
- BUG: Fixed STPPMA not working for 29 bit CAN protocols
- BUG: Fixed ATMP not working with J1939 configured USER1 preset until protocol was opened
- BUG: Fixed OUT OF MEMORY issue related to async CAN processing



v5.6.19 - 2021/06/30
--------------------

- Initial release
